First off, an apology to anyone who’s offended by the terms “slave” and “master” drive, but those are the terms currently used, and some people who’ve heard of the technique won’t recognize it without that label. This is the last you’ll hear of them, though.
If you have a lot of stuff on an [...]
First off, an apology to anyone who’s offended by the terms “slave” and “master” drive, but those are the terms currently used, and some people who’ve heard of the technique won’t recognize it without that label. This is the last you’ll hear of them, though.
If you have a lot of stuff on an old computer which you’d like to transfer to a new computer, and the old computer is incapable of cabling with the new one and simply sending over the info, there’s still a way to make it happen. You can also install the old hard drive as a second drive in the new machine, but if your old machine is too old to cable, the hard drive may be near the end of its life already.
Unplug the old computer and open up its case. Look for the hard drive. Detach the hard drive’s power supply cable and the ribbon cable from the back. Remove the screws that hold the drive in place. Take the the hard drive out of its bay. Set the hard drive as a “slave drive” - there should be a diagram on it that shows you how to do this with the jumpers. Now shut down the new PC and open its case.
Put the old hard drive into an open bay at this point, then attach a power cable and a ribbon cable to it. Close the new machine and turn it on. You may need to reset your BIOS, or it may immediately recognize the second drive. Now you can start moving stuff over by simple click and drag. Again, if the old hard drive is very old, it is recommended to move everything instead of relying on it.
Fire up the computer and see what happens, some will detect a new hard drive with no problems at all, you take no further action while some might need the bios changing - again it’s not hard you press delete on start up to enter the bios, then use the arrow keys to highlight the area you need, save your changes by pressing certain keys and then restart.